Bafang E25 error — cause + fix
As an Amazon Associate, Fix My Ebike earns from qualifying purchases.
Bafang E25 showing on your ebike display? It means: Brake signal abnormal. Full diagnosis + fix below.
What Bafang E25 means
Brake signal abnormal
Most likely cause
Brake sensor stuck in 'engaged' position, or brake cable pulled/cut
How to fix it
Disconnect brake sensor from controller — if ebike works normally with it disconnected, confirmed sensor fault. Replace or adjust the sensor lever position on brake lever.
Full diagnostic walkthrough
This error code points at a specific problem. For the complete diagnostic flow with multimeter tests and replacement options, see the dedicated guide:
Which ebikes this code affects
Ebikes with motor-cutoff brake sensors.
Diagnostic tools you'll need
AstroAI digital multimeter
Best for: Verifying voltage-related causes of E25
- Auto-ranging DC
- Continuity beep for connector tests
- ~£15 on Amazon UK
Contact cleaner + dielectric grease kit
Best for: Resolving connector-related E25 errors
- DeoxIT-grade cleaner
- Silicone dielectric grease
Self-amalgamating rescue tape
Best for: Sealing connectors after fixing to prevent recurrence
- Self-bonds, waterproof
- Removable for future service
Clearing the code
Most Bafang codes auto-clear once the underlying fault is resolved. If the code persists after fixing:
- Power off the ebike completely (remove battery).
- Wait 60 seconds (capacitors discharge fully).
- Reinstall battery, power back on.
- Code should be gone if the fault was addressed.
If this code keeps coming back
Intermittent errors usually mean the fault is intermittent too — typically a loose connector, partially broken cable, or a component failing gradually. Don't ignore it; intermittent faults almost always worsen until they become permanent. Work through the related diagnostic flow linked above to find the root cause.